Angular sensors
TRS.184
The TRS.184 is safety angular based on a double CPU, a double 3D-MEMS accelerometer and a double gyroscope, in a fully redundant circuit scheme.
Using a special algorithm, the device can filter and improve the measure accuracy in presence of vibration and acceleration loads.
It can be implemented as SLAVE in a CAN network.
The polyurethane resin case makes the sensor suitable for use on machines that operate in harsh work environments.
TRS.ALMX
The TRS.ALMX is a safety angular inclinometer sensor based on a double CPU, a double 3D-MEMS accelerometer and a double gyroscope, in a fully redundant circuit scheme, with 2 independent CAN-Bus lines.
In according to the regulatory standards, the termination resistors are permanent and electrically measurable even with the device off.
The connector is an M12 with 8 poles.
Using a special algorithm, the device can filter and improve the measure accuracy in presence of vibration and acceleration loads. It can be implemented as SLAVE in a CAN network.
The polyurethane resin case makes the sensor is suitable for use on machines that operate in harsh work environments.
TRS.QEU
The TRS.QEU is an angular sensor quick and easy to use.
It’s based on a single CPU and a single 3D MEMS accelerometer.
It can be implemented as SLAVE in a CAN network.
The polyurethane resin case makes the sensor issui table for use on machines that operate in harsh work environments
TRS.2SSR
The TRS.2SSR is an angular sensor based on a single CPU and a single 3D MEMS accelerometer.
This model provide to switch a relay with dry contacts on a set threshold value.
It can be implemented as SLAVE in a CAN network.
The polyurethane resin case makes the sensor is suitable for use on machines that operate in harsh work environments
TRS.TCM
The TRS.TCM is a safety angular sensor based on a double CPU and a double 3D MEMS accelerometer, in a fully redundant circuit scheme, with two independent outputs both 0-5 V and 4-20 mA.
It can be implemented as SLAVE in a CAN network.
The polyurethane resin case makes the sensor suitable for use on machines that operate in harsh work environments.
TRS.ETMB
The TRS.ETMB is a safety angular based on a double CPU and a double 3D MEMS accelerometer, in a fully redundant circuit scheme, with a safety based relay output switch.
The logic output is configurable by software. It allows to emulate the functioning of a toroidal mercury bubble or a independent axes rectangular system.
It differentiates the X-, X+, Y-, Y+ axes as well as to get separate offset. It can be implemented as SLAVE in a CAN network.
The polyurethane resin case makes the sensor suitable for use on machines that operate in harsh work environments.